A device designed to filter and transfer data packets between dissimilar types of computer networks is called:
Which of the following answers refers to a data link layer (Layer 2) device designed to forward data packets between Local Area Network (LAN) segments?
A security solution implemented on an individual computer monitoring that specific system for malicious activities or policy violations is referred to as:
Which of the following answers illustrates the difference between passive and active security breach response?
- Shuffle
Toggle On
Toggle Off
- Alphabetize
Toggle On
Toggle Off
- Front First
Toggle On
Toggle Off
- Both Sides
Toggle On
Toggle Off
- Read
Toggle On
Toggle Off
Card Range To Study
through
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
- Share
- Export
- Clone
25 Cards in this Set
- Front
- Back
A type of network consisting of computers and peripheral devices that use high-frequency radio waves to communicate with each other is commonly referred to as: | WLAN | |
The disadvantage from using this device results from a fact that any incoming signal on any of its ports is re-created and sent out on any connected ports, which in turn forces all the connected devices to share the total amount of available bandwidth. | Hub | |
Which of the following answers refers to a data link layer (Layer 2) device designed to forward data packets between Local Area Network (LAN) segments? | Switch | |
A device designed to filter and transfer IP packets between dissimilar types of computer networks is called: | Router | |
An infrastructure device designed for connecting wireless/wired client devices to a network is commonly referred to as: | Access Point (AP) | |
What type of device would be the most convenient for interconnecting two or more physically separated network segments? | Wireless bridge | |
Which of the devices listed below allows for establishing a communication channel over a PSTN? | Analog modem | |
Which of the following devices can be installed in an AMR slot? | Modem | |
A software or hardware that checks information coming from the Internet and depending on the applied configuration settings either blocks it or allows it to pass through is called: | Firewall | |
A simple device consisting of multiple computer ports arranged in rows used for the purpose of cable management is known as: | Patch panel | |
A type of network device that amplifies received signal so it can be transmitted over greater distance without loss in quality is called: | Repeater | |
Which of the answers listed below refers to a network device that allows to overcome limitations related to the maximum allowable cable segment length? | Extender | |
A computer networking technology that enables sending data over wiring used for transmission of electrical power is called: | PLC | |
Which of the following acronyms refers to a solution that allows for carrying both data and electrical power over a single twisted-pair Ethernet cable? | PoE | |
Which of the following tools would be used for attaching RJ-45 connectors to a twisted-pair Ethernet cable? | Crimper | |
What is the name of a tool used for removing electrical insulation cover from electric wires? | Wire stripper | |
Which of the tools listed below would be used for testing power supply voltage output? | Multimeter | |
What is the name of a networking tool used for locating a cable in a cabling bundle or tracing individual wires in a cable? | Toner and probe kit | |
A type of tool used for verifying correct electrical connections of wires in a cable is known as: | Cable tester | |
While troubleshooting problems with a Network Interface Card (NIC), connector pins on the NIC's port can be tested with the use of: | Loopback plug | |
Which of the networking tools listed below is used for attaching wires to a patch panel? | Punchdown tool | |
Which of the following networking tools would be of help in determining the optimal placement of a WAP? | Wi-Fi analyzer | |
A hardware solution designed to extend the functionality of a laptop computer by providing the capability to add various types of devices on an external expansion card is called: | ExpressCard | |
A hardware technology designed as a replacement for the PCMCIA standard is called: | ExpressCard | |
ExpressCard /34 and ExpressCard /54 are two form factors specified by the ExpressCard standard. Numbers after slash in these two form factors refer to the card's: | Width |